Elongation at break
Type of adhesive
Tensile strength
Total Thickness
Backing material
Color

Before using our adhesion promoter, the bonding surface, i.e. the substrate, should be free of dust, grease, oil, moisture, and other contaminants. Therefore, we highly recommend cleaning the substrate with a lint-free cloth using solvents, such as ethanol or isopropanol alcohol or our Tesa® 60040 Industry Cleaner. Once the surface has been cleaned, you can go ahead and apply our Tesa® 60151 Adhesion Promoter. We recommend applying our adhesion promoters with a lint-free cloth, brush or sponge. Wet the cloth thoroughly with Tesa® Adhesion Promoter and wipe once and in a single direction over the surface. Immediately use another lint-free cloth to remove excess adhesion promoter from the surface- a squeaking noise indicates a good layer thickness on most glass types. The entire surface should be coated thinly with adhesion promoter in order to reach the highest bonding performance. It is important to wait at least 30 seconds (and a maximum of 5 minutes) in order to give solvents time to evaporate. Please make sure to keep the prepared surface free of contaminants prior to applying the tape. Once the substrate has been properly pre-treated with Tesa® 60151 Adhesion Promoter, the bond should be established within 15 minutes. Please note that due to the multitude of available substrate formulations in the marketplace, it is recommended to test our Tesa® Adhesion Promoter prior to usage. • The shelf life of this product amounts to at least 12 months when stored at room tem-perature in its sealed original container. • For further information and advice on safe handling please refer to our safety data sheet (SDS), which is available upon request.